3D Scenarios

- Polyprod 3D Scenarios: Production control interventions

Process operation and change of proportioning parameters (analyzing technical functions, sampling jars and weighing them on a virtual scale, filling in the control chart, reporting a deviation and adjusting the parameters of the proportioning pump to restore production)

Production and operation in degraded mode (analyzing the functions, performing quality control and reporting a non-conformity in jar cap tightening, deciding to continue production without the caps with the line controller, removing the screwing head for the maintenance technician, configuring production without the caps, producing, reassembling the screwing head after the technician’s intervention, organizing time periods to reprocess the caplessjars and fill in the production sheet)

Learning procedures of production commissioning and qualification (setting parameters for a production campaign, adjusting, qualifying the production)

Air Handling Unit 3D Scenario: Maintenance and electrical accreditation interventions

Replacing a contactor in the electrical cabinet (analyzing the technical functions, checking and putting on PPE, demarcating the work area, blocking the switching device, shutting the system, replacing the contactor, re-commissioning, validating operation and filling in the intervention sheet) ref: VS00-01

Replacing pulleys and ventilation belt (analyzing the technical functions, checking and putting on PPE, demarcating the work area, shutting the system down, replacing the pulleys and belt, aligning the pulleys, checking belt tension, re-commissioning the system, validating operation

Key points:

Realistic design of the simulation (3D factory)

Possibility to review the scene in order to understand one’s behavior and learn

Student’s work in full autonomy

Mistakes are possible with no risk for students and equipment

References :

VS010-01 : Process operation and change of proportioning parameters

VS010-02 : Production and operation in degraded mode

VS010-03 : Learning procedures of production commissioning and qualification

VS00-01 : Replacing a contactor in the electrical cabinet

VS00-02 : Replacing pulleys and ventilation belt